Originally posted by kohanson:
whats the angle you shot at?
to answer your question
i just tried it and measured the angle...about 10 degrees below the horizontal table...how
lite dat can pass or not
but trust my reading when i take reading very accurate 1
in my comnpany every engineer wait for me to take readings
for every new and existing products coz i am
bloo dy good at it
man...i am even posted to an ulu ulu place without measuring tools and i can measure, evaluate and even reject parts without
measurments man......wen ppl needed CMM most...i can do withou 1
man....now all new part ppl arso wait for my measurments man so trust
me on the readings i just gave you...veri true...how how can pass?
